If your garage door goes up and down in a jerky motion, you might have one broken spring on a two spring system. Some garage door openers are strong enough to lift a door with only one good spring. The “herky jerky” motion is especially common with garage doors equipped with extension springs. It might be something as simple as lubricating your garage door pulleys, hinges, and rollers. When in doubt or if something doesn’t feel right about your door, call a service company to have it serviced.

Perfect name for a FANTASTIC company! These guys are definitely ROCKSTARS!!! Our garage door stopped working late one evening (the perfect time for something to break, right?!?!). I found Rockstar Garage Door after calling another company who left me in the lurch for over 2 hours with zero help. I am SO thankful I called Rockstar. Ryan talked me through some troubleshooting ideas. When those didn't work, he hopped in his truck and came right over (he even called back to give me an accurate ETA based on his GPS). He got the door closed for us that night so safety and security weren't a concern and scheduled an appointment for the following day. On the day of our appointment, Ryan arrived early (after calling to confirm it'd be ok to do so). He fixed all the issues we were having with efficiency (we needed a new motor) and tripled checked everything. Ryan was professional, personable and answered all the questions I had. He walked me through the new setup making sure I understood how everything worked before leaving. Service was prompt and reasonably priced. I couldn't ask for better service and definitely recommend using this company. Thanks Ryan (and Rockstar Garage Doors)!!

best garage door repair company near me


Quite often homeowners are unaware of these cables until something goes wrong. Then the typical question might be ‘I see a wire hanging near my door’ or ‘the spring on my garage door doesn’t seem to be working but it doesn’t appear to be broken’. What should you do about a broken cable? First and foremost – remember a garage door is counterbalanced by springs to offset the weight of the product. We recommend against user service of the counterbalance system. Avoid using the door and call for service as soon as practical. Most cable replacements are simple, straightforward repairs. Other times there may be an underlying cause for a cable failure. As mentioned above bad bearings, worn parts and poor adjustment may all play a part in cable failure. A trained technician will evaluate the door system and replace parts as needed. In the case of cables it is generally good practice to replace the set if one has failed. This service will be completed with lubrication, adjustment and safety testing the door and opener system.
Installing an overhead garage door requires a few tools and a friend to help. First, the lower door panel needs to be set up in the center of the doorway. The remaining panels and tracks are held in place with hinges, brackets, and screws. Set up an easy-to-install torsion spring system to ensure that your door lifts properly for many years to come.
Daniel is outstanding with communication and provides the best prices in the area. He uses a professional garage door company that is higher quality than the big box stories. Daniel sent me the website of his door vendor and I was actually able to upload a photo of my house and add the garage door style to see what looked best. Molina Garage Door is very professional and has a wide coverage area in the central valley. My rental property is in Woodbridge near Lodi and that was no problem.
Self-storage roll-up doors operate in a similar manner to steel-rolling door springs. Like a steel rolling door, the curtain on these doors wraps around itself as the door opens. The primary difference, however, is that steel rolling doors are made of interlocking slats, while self-storage roll-up doors are just one piece of steel. While steel rolling doors are typically found in heavier commercial and industrial environments, self-storage roll-up doors are common in self-storage facilities.
Oklahoma City, Edmond, Norman, Moore, Tulsa, Broken Arrow, Owasso, Claremore, Central Oklahoma, Sapulpa, New Tulsa, Jenks, Glenpool, Prattville, Sand Springs, Leonard, Coweta, Kiefer, Oakhurst, Inola, Fair Oaks, Verdigris, Lotsee, Sperry, Justice, Valley Park, Bixby, Mannford, Cleveland, Westport, Prue, Bethany, Yukon, Midwest City, Spencer, Newcastle, Harrah, Jones, Piedmont, Arcadia, Luther, Wellston, Dell City, Tuttle, Bridge Creek, Blanchard, Mustang, Noble, Goldsby

quick garage door repair


When rust forms on the garage door springs it can cause the springs to easily break and the life cycle of them to be shortened. Rust causes friction on the coil and weakens it as well. You can prevent spring breakage due to rust by spraying down the coil with a lubricant every few months (we can provide this), which keeps it both lubricated and from building up with rust.

how much for roller door


Garage door cables can and do break on occasion. One reason the cable might break is simply age. Cables experience wear and tear just like any other working part. Over time, the cables can weaken and eventually snap. Garage door cables also break because of rust. Rust can corrode the cable, and unless you catch it in time, the rust will have eaten through the cable. Fraying is another problem that causes garage door cables to snap. Picture a rope. Rope is made up of smaller pieces of rope twisted together to make a thicker cord. Garage door cables work the same way. A lot of little wire cables are wound together to make a stronger, thicker cable.  If one of these little cables breaks, it could fray the other little cables around it until the whole thing eventually snaps.  No matter the cause, a broken cable is a big problem and warrants a call to a certified garage door repairman.
In order to replace your garage door spring(s), you will need to find the current measurements in order to accurately replace the spring(s). This should take about 3 minutes and you don't need to remove the springs or loosen the tension to measure them. Our springs are made to be a bit flexible, so you don't have to get it to an exact measurement.  

how to garage door repair pulley


I told several people that I planned on installing a garage door torsion spring after mine broke. ALL of them told me that it was too dangerous and a few feared for my life! Honestly it was one of the simplest home repairs I have ever done. That is thanks in large part to your very helpful installation video. Your videos on measuring springs etc. were also very helpful. All of the necessary details are there.

Because garage doors are large, heavy, and mildly complicated, most people who buy them take advantage of these services. But, if you’re pretty adept at DIY tasks, you can save some money and enjoy the satisfaction of doing the job of installing a sectional garage door yourself. (Sectional garage doors travel up and down on rollers that ride along tracks at each side of the garage doorway.)


Test the door balance. A garage door should require only a few pounds of pressure to move it up and down. If springs wear out and lose their resiliency, a power garage door opener may need to work extra hard to lift the door. This can quickly wear out the motor on the opener. Replacing worn-out springs is usually a job for a professional technician.
So your garage door is acting up, but you aren’t sure what the problem is. Maybe the door spring is one possible culprit, but you’re not sure if that’s actually the problem or if it’s something else. In this quick list, we’ll go through the most common broken garage door spring symptoms. If your garage door is exhibiting one or a few of these symptoms, there’s a good chance it’s broken and needs replacing.
Technician gave me a window of 1-4pm, I called at 330 to see if he was on his way. He told me he would be there at 4pm, reason being was because of the amount of work orders he had that day. He was also by himself, had no helper. I was very satisfied that he was able to repair my garage door. He was very professional considering he showed up on a Friday afternoon on a 100 degree day. Thanks again
Single panel doors can also be installed with (one piece track type hardware) that folds the door back with a single horizontal track on each side (which is mounted at the top of the wood frame) and a roller, (mounted to the top of the door on each side. A hinge on each side that attaches to the bottom of each side of garage door. Using track hardware, a car can be parked much closer to the door, as the whole door, when in the open position, rests completely inside of the garage door header. Track type hardware has much less arc when raising and lowering the garage door as opposed jamb type hardware.[citation needed]
×