So your garage door is acting up, but you aren’t sure what the problem is. Maybe the door spring is one possible culprit, but you’re not sure if that’s actually the problem or if it’s something else. In this quick list, we’ll go through the most common broken garage door spring symptoms. If your garage door is exhibiting one or a few of these symptoms, there’s a good chance it’s broken and needs replacing.

how much are garage door windows


I'm looking about spanning 15' for a gazebo. trying to figure out what dimension beams I need. The Gazebo will be 15'x10'. How big will the beams have to be. at 1/2 the distance on 15' I will have a perpendicular beam running to carry 2x4's running parallel to 15' beam edge. I live in California in there with be no roofing material.. I will be using redwood for lumber Thanks
Rolling sectional overhead garage door spring replacement should cost somewhere between $195 to $300 for a quality set springs (50000 cycle rating). This price will very if the garage door repair company charges a service call fee (trip charge). The most important thing to consider along with price is the quality of the springs and the warranty. There are any company that we use lower or mid quality springs and charge on the higher end because they include a lifetime warranty on the springs. The catch is that this warranty will only covers the spring for life and labor only for 30 days to a year. Look for a company that offers a equal parts and labor warranty. This insures that the warranty represents the rating of the springs that are being installed. For instants, you may buy a 1500 cycle rated spring set (last 3 years +or-) for $200 with a lifetime warranty and 1 year on labor. When a spring brakes after 3 year the spring its self is covered but the labor cost to replace the warranty spring can be between $65 to $100. This can add up over the year as the warranty will not restart at the time of the warranty replacement. On the offer hand, if you purchase a set of springs rated at 50000 cycles (last 10 year +or-) for $270 with a 10 year parts and labor warranty and a spring brakes in 8 years it would be replace at $0 cost. A must batter value! Always check service company review and get the details on the quality of springs a garage door repair company uses and the warranty, part and "labor".

My garage door broke on a Saturday night as I was getting ready to leave for a holiday party. Kelvin was here within 30 minutes. He reviewed everything with me that was happening with my door. He gave me the estimates of what was immediately needed to be done in order for my door to raise and then what I will need to have done very soon. I could see all the problems he pointed out to me and I decided to have everything done. He completed everything that night. I was very satisfied with Kelvin’s professionalism and the work he did. Thank you again.
Replacing a garage door panel can add significantly to the cost of a garage door repair. Panels run horizontally on sectional roll-up garage doors. They may be made of wood, vinyl, aluminum, fiberglass or steel. Garage door panels can become damaged from hail and other extreme weather, dents and dings, car accidents, and age. When deciding if you want to replace a garage door panel, it’s helpful to compare the potential repair cost to the cost of a new garage door. Panel replacement requires a pro with the proper tools as well as the new parts. With parts and labor you could be paying more than $500 for one new panel. In comparison, a new garage door may cost $800-$1,200 (on average) with installation. If there is a possibility your garage door was structurally compromised when the panel was damaged, have the pro assess whether it’s better to completely remove and replace the door, rails and framework to ensure your home’s safety. It may also be better to completely replace your door if it is severely rusted or dented; if the paint is peeling and fading; if the door model is outdated or you can’t find replacement panels; or if the panels or rails are structurally compromised.

A standard double garage door is 7 ft. high by 16 ft. wide. Standard single doors are 7 ft. high by 8 or 9 ft. wide. Because the doors are so large, few home centers and only some garage door stores keep many doors in stock, so expect to order one instead of buying it off the shelf. Garage doors are available in wood, fiberglass and steel. Steel doors, like ours, are light, maintenance-free, affordable, readily available, and have an insulating value as high as R-19.


Garage door manufacturers typically produce garage doors fitted with torsion springs that provide a minimum of 10,000 to 15,000 cycles and are guaranteed for three to seven years. One cycle is a single opening and closing sequence. Most manufacturers offer a 30,000 cycle spring. However, it is important to remember that if the weight of the garage door is increased by adding glass, additional insulation, or even several coats of paint, the life of the torsion spring may be greatly reduced. Additionally, springs at highly humid environments, such as coastal regions tend to have a significantly shorter cycle life, due to the corrosive cracking.

Always good to hear that our technicians are keeping up our Rockstar standards. We like to hold our communication with all clients or potential clients at a top priority. We will always do our best to respond and give our best options and solutions for anything garage door related. Please feel free to contact us with any future garage door needs. Read more

Of course my garage door cables decided to snap at 5 PM on a Friday, leaving my garage door partially open. I searched yelp and started making calls and leaving voicemails and i figured i was out of luck. Daniel called me back and I told him what happened. Long story short, he showed up in an hour and fixed the cables and even tuned up my garage door. Not only is my garage door fixed, it's a whole lot less noisy and opens and closes smooth unlike before. Daniel was extremely friendly and he came last minute which saved my weekend. I highly recommend Molina garage door services and will be using them from now on.

overhead garage door repair


Imagine pulling up to your Mesa and Phoenix home or business and seeing a beautifully customized garage door that transforms your space. You’ll get just that when you choose JDT Garage Door Service to install your new doors. We deliver numerous options including non-insulated, insulated, steel and wood overlays. Make your residential or commercial property in Mesa and Phoenix stand out from the crowd with a unique door. Bring your ideas to our technicians and we’ll match you with our available options or call us so we can provide you with choices you’ll love. Get same or next day installation service and a free estimate by contacting the garage door professionals at JDT Garage Door Service in Arizona.
  I have nothing but nice things to say about Turbo Garage Door!  I had my new garage door opener installed about a month ago and it's been working great until about a week or so ago.  All of a sudden the door started popping up right when it was almost down to ground closed.  I played with it and determined that a support beam on the door seemed to be interfering with the safety sensors.  I called Turbo Garage Door for help and they were able to come out the next day.  And help they did!  The tech found the problem right away, and with a couple of well placed screws, the door was working great once again.  The problem was with the door, not the equipment that they installed, but they came out to solve the problem for me.  I would recommend Turbo Garage Door in a hot New York second!

how to get garage door up when power is out


The technician, Robert Helton, was very pleasant, helpful, and professional. He repaired the garage door opener expeditiously and explained why it hadn't worked properly. He also checked the chain mechanism and the door itself and showed me how to manually work the door should I need to do that in the future. I was very pleased with this repair work.
A few different things can go wrong with garage door cables. For one thing, some cables have been known to get wound around the drum incorrectly so that the door becomes jammed, often drooping on one side, or the door will catch as it is being lowered.  Cables have also been known to become completely unwound from the drum and will need to be reconnected. Sometimes the pulleys can get worn out. When this happens, the cable won’t slip through as smoothly, and you’ll again notice that your door becomes stuck or cocked to one side. If this is the case, the pulleys will need to be replaced.

does homeowners insurance cover garage door repair


Another scenario is the garage door goes up very slowly when using the automatic opener. Some garage door openers have DC motors that start off slow when opening and then kick into a higher speed. If you have a broken spring, the opener might stay in the slower speed due to the heavy weight of the garage door. If this happens to you, close the garage door and pull the emergency release rope. Next, try to lift the door. If it is really heavy, then you most likely have a broken garage door spring.
A garage door is a large door on a garage that opens either manually or by an electric motor (a garage door opener). Garage doors are frequently large enough to accommodate automobiles and other vehicles. Small garage doors may be made in a single panel that tilts up and back across the garage ceiling. Larger doors are usually made in several jointed panels that roll up on tracks across the garage ceiling, or into a roll above the doorway. The operating mechanism is spring-loaded or counterbalanced to offset the weight of the door and reduce human or motor effort required to operate the door. Less commonly, some garage doors slide or swing horizontally. Doors are made of wood, metal, or fiberglass, and may be insulated to prevent heat loss. Warehouses, bus garages and locomotive sheds have larger versions.

If you pull the red emergency release rope on your automatic opener and you still can’t lift the garage door, you probably have a broken spring. The counterbalance spring is what lifts the garage door, not the garage door opener. If the spring is broken, the door is dead weight. A garage door can be lifted, but it is going to require some muscle to get it up. It is also important to lift the door evenly so it does not jam in the tracks.

how to garage door seal replacement


I immediately received a call back after leaving a message and got a same day appointment. Ryan, the technician, came out within the time frame quoted, was kind and super knowledgeable about garage doors. He quickly figured out that our keypad was not programming because of its location and the fact that it does not transmit through steel (which our garage door is partly made of). He installed an updated, more compatible keypad within minutes and like magic, we had a functioning keypad! He was kind enough to stay afterwards to explain the different functions on our garage door as well. On top of their stellar customer service, their prices are competitive and reasonable. The service fee was $89 and the keypad replacement was $75.
The electronics should also be inspected before or after investing in the cost of replacing the garage door panel to make sure your door will operate properly. The sensors prevent the door from closing on someone's foot or a pet. If they don't work, someone could be injured. Also check to make sure the door opener works, since you could otherwise be locked out of your garage.
Align the upper roller tracks by carefully lifting the door halfway. Lock it in place with two locking pliers, and install the supporting brackets on the back of the rails using 1-1/4 in. perforated angle iron (available at home centers and hardware stores). Install 1-1/2 x 1/4 in. stop bolts, with the threads to the inside of the track, at the end of each upper track.

torsion spring garage door repair


When the lay-person typically sees a circuit board, they immediately seize up and think that's it's too advanced for them to fix. In reality, replacing circuit boards for the Chamberlain Liftmaster, Sears, and Craftsman garage door openers is relatively easy with proper instruction. This video will walk you through the process of replacing the circuit board on a Chamberlain Liftmaster, Sears, and Craftsman garage door opener.

yellow pages garage door repair


Carriage: These doors mimic the look of doors found on old carriage houses in the days of horses and buggies. Because of their rustic look, they are often favored in the West and Southwest of the United States. The doors swing open like oversized French doors and hang from jambs on hinges. With their unique look, they create an area of visual interest for your home and are quite energy efficient. The downside is they require a considerable amount of clearance to work properly. Because most carriage garage doors are largely composed of wood, you may need to replace deteriorating or rotting door materials. The average cost for carriage garage door repairs is $133.
In order to replace your garage door spring(s), you will need to find the current measurements in order to accurately replace the spring(s). This should take about 3 minutes and you don't need to remove the springs or loosen the tension to measure them. Our springs are made to be a bit flexible, so you don't have to get it to an exact measurement. 

how much are garage door remotes


Install the pulley at end of rail, opposite the motor compartment. Then feed the belt or chain through the end of the rail, around the pulley, then around the other end (at the motor). Finally you will attach the end of the belt or chain to the carriage. The end of the chain or belt should have a screw attached to it, so that you can easily attach it to the carriage. This screw will also allow you to adjust the tension of the chain or belt.[3]
Sure, wear and tear can eventually cause the garage door springs to break down. But, by practicing proper maintenance you can prolong the spring’s life. The first thing to do is spray down the coil with lubricant at least three times every year. Additionally, you should check up on the garage door balance every season. We have found that most people have spring failure issues in the winter, so checking it more frequently during that time is recommended.
Installing an overhead garage door requires a few tools and a friend to help. First, the lower door panel needs to be set up in the center of the doorway. The remaining panels and tracks are held in place with hinges, brackets, and screws. Set up an easy-to-install torsion spring system to ensure that your door lifts properly for many years to come.

sears garage door repair service


Jerrod the technician had answers to all my questions. He was very knowledgeable and very patiently explained what was going on with my garage door and the opener. I would definitely recommend A1 garage door service to friends and family. I was given options to either repair the door or replace it. I will get the door replaced when it gets non-functional from A1 garage door service.

where to buy garage door parts


Thank you so much for being available and sending Ryan out to fix our garage. The door wasn't closing and finally I noticed 2 rollers off the track. Afraid the door would fall and also afraid to leave it open overnight I searched for 24 hour service. 30 minutes later Ryan arrived and fixed the door, lubricated the track and hinges and tightened everything up. I definitely feel safer knowing the door is in place. He also helped me program my homelink and taught us safety features we didn't know about!
The history of the garage door could date back to 450 BC when chariots were stored in gatehouses, but in the U.S. it arose around the start of the 20th century. As early as 1902, American manufacturers—including Cornell Iron Works—published catalogs featuring a "float over door." Evidence of an upward-lifting garage door can be found in a catalog in 1906.[4]

I told several people that I planned on installing a garage door torsion spring after mine broke. ALL of them told me that it was too dangerous and a few feared for my life! Honestly it was one of the simplest home repairs I have ever done. That is thanks in large part to your very helpful installation video. Your videos on measuring springs etc. were also very helpful. All of the necessary details are there.
×